Why are my rear running lights not working?

One of the main reasons why you might see your brake lights working while your tail lights don’t is because the bulbs installed in the tail light were faulty. You should run some tests to make sure if the bulbs are the main culprit or not and to do that, you will need to remove the tail light cover.

How do you reset the dash lights on a Chevy Impala?

Method 3

  1. Keep clicking the Information button until you see OIL LIFE REMAINING preceded by a number.
  2. This is how much oil life is left.
  3. Press and hold down the Checkmark button for 5 seconds, the number should reset to 100%
  4. Click the Road button to return to normal dash display operation!

Where is the fuse for my dashboard lights?

Find the fuse that powers your dashboard lights. Check under the hood, under the dashboard, or near or in the glove compartment. Once you find the fuse box or boxes, remove the lid and check the diagram on the underside of the lid for a fuse labeled “dash lights” or just “lights.”

How much does it cost to fix tail light fuse?

And finally, if you want to fix the fuse of the affected lights or change it, the average cost will amount from $50 to $150.

How do you reset the check engine light on a 2005 Chevy Impala?

There’s no proprietary way to reset the ’05 Impala’s check engine light — You’ll either need an OBD-II scan tool, or a bit of patience. In the first case, You should be able to clear the associated codes, and the light will go out on its own.

How do you reset the computer on a 2005 Chevy Impala?

How to Reset a 2005 Chevrolet Computer

  1. Pop open the hood of your Chevy and locate the negative battery terminal. On this terminal is a clamp that has a nut attached to it.
  2. Wait 30 minutes then put the negative battery clamp back onto the negative side of the battery. Tighten the nut with the end wrench.